At you the energy saving lamp, and not one, and has burned down a little? You do not hurry to throw out at once the fused lamp as energy saving bulbs can be repaired independently, and as a last resort to use their separate parts for repair of daylight lamps.
Instruction
1. Modern energy saving lamps fuse because of failure of spiral of heat or burn-out of its electronic scheme, but only thorough analysis of the bulb will help to find out the cause of breakage. Take energy saving lamp, sort it, accurately hooking the screw-driver the feature connector on clothes pegs located in middle part of electric bulb. To repair energy saving lamp, sort it so that part of the device with spiral of heat was separately from all rest of bulb, connecting to it only the wires provided by manufacturer.
2. Separate upper part of energy saving lamp together with the cartridge twisted in chandelier from internal stuffing of lamp with the electronic scheme. For this purpose turn off plastic or ceramic flask, then carefully pull out the electronic scheme. Wishing to repair independently energy saving lamp, carefully bite off supply leads. Ring out heats of flask for decision-making whether it is possible to repair it, or such lamp needs only to be thrown out or used on spare parts subsequently.
3. If has fused one or both spirals of heat, the flask should be thrown out as repair of energy saving lamp in this case is impossible. And keep the electric circuit – perhaps, it will be required then for implementation of repair of other fused bulbs. When you have available several fused energy saving lamps, in one of them the flask, and another – the electric circuit has fused, collect one working bulb from two failed lamps. Having picked up new wires of suitable section, attach with their help to working flask the electric circuit removed from other bulb, using the soldering iron.
4. Close flask, having screwed up it in the place of assembly and having established factory tucks on the former place. In case when at you only one fused energy saving lamp with the failed heat spiral has remained, remove from it electric payment which perfectly will be suitable for modernization of the daylight lamp. Solder four big wires of the daylight lamp to places of the electric circuit where earlier the "native" flask fastened. Two such wires have to go on heats, connect the second two to network fork, and then you will need only to connect the daylight lamp to the socket.