The ladder is important element of interior in two- or three-storyed houses. If the concrete formwork is already cast, it can be sheathed tree and to establish special protection.
To sheathe ladder tree it will not turn out without the special equipment. Such process surely will require such tools as: set of screws and the screw driver, rubber hammer and tesanok, construction level, pencil and ruler and also pins for fastening of rail-posts. After preparation of these things it is possible to start directly shingling of ladder.
It is better to begin work with dimensioning of parts of ladder which you will sheathe. Then it will be required to vytesat from wood all necessary elements for facing. After training of all stair risers and steps it is possible to be accepted to finishing of tree under handrail. Also it is necessary to decide on design of rail-posts. They can also be different form and height. The interval between rail-posts has to be not less than 10 cm. Handrail needs to be cut at first in length, and then at the edges to correct their width and form. It is worth to remember also about cutting out of inside of handrail.
Fixing of parts from tree on metal framework will become the next stage of work. Such work will require the screw driver. On the corresponding parts of ladder wooden parts are imposed. The right places if necessary can be noted pencil. At the same time each step has to correspond to certain part of ladder completely.
Fastening of steps has to result so that steps were given a little forward. It is better to fix them from above by the screw driver. By means of construction level it will be necessary to check all steps for durability also. Now it is possible to pass to stair risers. They need to be fixed so that each stair riser rested against ladder framework. Upon termination of work it will be required to check flatness and durability of parts again. On closing stage of covering of ladder it is possible to fix handrail and rail-posts. Places of future fastenings have to be marked so that between rail-posts there was identical distance. After installation of rail-posts it is recommended to check their vertical position. If the rules are respected, it is possible to start gradual fixing of rail-posts by means of special pins. After that it is necessary to begin to fix handrail directly on rail-posts. For reliability they are recommended to be fixed special pins. Registration of ladder framework becomes possible only after acquisition of the necessary quantity of screws, gypsum cardboard and also panel boards.