Small-sized inflatable pools enjoy wide popularity among the population recently. They are very comfortable: are easily mounted, are easily transferred, do not demand big financial investments. But are often damaged at installation on unprepared surface, especially when they are put in the yard or on personal plot. Besides sometimes suffer from pets (cats, for example, like to sharpen claws and at the same time can puncture such pool). It is possible to stick the damaged site in several ways.
- wide and superficial container with water, marker, set for cold curing, the reinforced adhesive tape, scissors, TRS 2002 glue, rubber patch, the clamp, small abrasive paper, small brush for shaving or soft hair brush, laundry soap
1. Inflatable pools are made of PHV, rubber, the rubberized fabric. Each material requires the method of repair. But first of all find the place of puncture. For this purpose slightly pump up the pool. Parts if is not located entirely, submerge it in water. Determine the place of puncture by the air bells leaving puncture opening. Note the found place of puncture of marker.
2. If the pool bulky and to use such method there is no opportunity, use such method: Wet laundry soap, by means of small brush or hair brush shake up foam. You apply foam on the surface of well beefy pool. Determine the place of puncture by the air bubbles which are blowing up under foam. Note the damaged place marker.
3. If it is required to stick quickly and temporarily damaged place, use adhesive tape. Before sticking up slightly to zachistta the damaged site small abrasive paper. Accurately cut off piece of adhesive tape, necessary by the size. Do not concern sticky surface of adhesive tape! Put patch on the damaged site. After such temporary repair the pool will serve about a week. For major repair use special patches from automobile set for cold curing of cameras. Zachistte abrasive paper the damaged site. Remove protective film from the gluing party of patch. Densely press the clamp patch to the damaged site. Remove the clamp in 1 hour. Stick the damaged site on the rubberized fabric by means of TRS 2002 two-part adhesive.