Wholly to use the potential of opportunities of heating boiler, it is necessary to establish correctly it and also to attach to the system of water supply and heating. In other words, it is necessary to make boiler binding.
It is required to you
- - set for connection of the pump;
- - block for monitoring temperature and pressure;
- - universal boiler collector.
Instruction
1. Execute installation of boiler collector (as the hint the sticker located on its body with the indication of the return and giving line will serve). To boiler attach the tube departing from universal collector with diameter 1¼", and to the system of the pipeline – with diameter of 1''. If the binding of one contour is made, then close side openings stubs. Over time these openings can be used for connection of expansion tank, additional collector or for filling of heating system with the heat carrier.
2. On entrance of boiler collector install the three-way mixing valve: it will allow to regulate heat carrier temperature. For the purpose of the organization of regulation of separate low-temperature contours, for example, it can be "heat-insulated floor", install the three-way valve at the exit of boiler collector.
3. Pick up set for connection of the pump (the main attention at the same time should be paid to height of circulating pump which has to be 130 or 180 millimeters). Make mounting of the pump on the return line. If contour radiator, then the pump attach to the most boiler collector and if contour low-temperature – connect it after the three-way block.
4. After the pump install the block of temperature control and pressure consisting of two valves with thermometers and one differential valve. Perhaps, this block is the last element of binding of boiler of heating.