Warming of the house from foam concrete is one of topical issues which many house owners face. Warming of the house allows to save means which would be necessary for room heating, in cold season.
It is required to you
- - drill with drill of the corresponding diameter;
- - perforator;
- - palette;
- - nozzle "Mixer";
- - construction scissors;
- - bucket;
- - capacity for glue;
- - level;
- - glue;
- - polyfoam plates;
- - tape measure;
- - fibreglass mesh;
- - perforated corner;
- - mineral wool;
- - wooden reechka;
- - hammer;
- - nails;
- - paroizolyatsionny and thermal insulation materials.
Instruction
1. On perimeter of polystyrene foam plate and also apply glue on its middle. Bring this sheet of polyfoam to building wall. Hold this leaf during poluminuta: it will give the chance to grab glue. Glue polystyrene foam sheets so that connecting seams between them were not located in one row, that is mount them with bandaging - it will allow to prevent cracking of seams.
2. Fix Pokleenny sheets from polyfoam on wall by means of dowels with shafts (they are called "umbrellas"). Strengthen leaf core one or two "umbrellas", and other fastening elements arrange on corners of polystyrine leaf and on joint between plates.
3. Cover all "hats" of dowels with glue. On the bottom and top polystyrine slabs miss fibreglass mesh: it considerably will facilitate performance of stucco work. Then wall poshtukaturta, let's them dry, and later paint facade or apply decorative plaster.
4. wall heater which fix by nailing down to wall wooden reechek.
5. Warm ceiling from outer end: lay paroizolyatsionny material, then on it layer of thermal insulation material, and from above throw one more layer of vapor barrier.