The interior finish is the last step in creation of the construction intended for reception of bathing procedures. Finishing of bath means not only observance of bathing canons, but also the correct selection of materials. Therefore before getting to work, it is necessary to study carefully some nuances of finishing of bath from within.
The quality of finishing of bath theof hands depends on right choice of material. At the same time it is absolutely optional to stop on one type of wood as the combination of several breeds of tree is capable to give to bath special chic and cosiness.
We choose finishing material for bath
When choosing finishing material it is very important to know properties of any given tree. Otherwise stay in bath will bring one disappointment instead of pleasure.
The larch or linden as these breeds do not overheat will be ideal for sweating room, so, they are not capable to leave burns on skin. It is undesirable to use pine in this case as it when heating emits pitches which at contact with skin of the person cause discomfort. Coniferous breeds are ideal for finishing of the waiting room where air temperature is much lower than sweating room. The healthy coniferous aroma will create ideal conditions for improving effect. For washing where the level of humidity is on the maximum mark, it is the best of all to use the fir-tree or pine lining differing in high resistance to rotting and moisture. Except lining for finishing of this room it is possible to use gypsum cardboard, aquapanel, PVC panels, gipsovolokno and tile. As for floor, for its finishing it is the best of all to use oak. The difference of such floor covering is that it does not slide and has low thermal capacity. And it, as we know, allows to exclude the probability of receiving burn when walking on such floor.
If for finishing of floor to use ceramic tile, then useful will be to lay wooden pallets against sliding on it.
Features of interior finish of bath
Lining is ideal material for interior finish of bath the hands. Besides it can be used not only for finishing of walls, but also for ceiling. The manufacturing techniques of lining give opportunity to decorate internal interior of bath under "log" or "bar". Besides walls, battened, do not demand additional treatment as this material at production phase becomes covered by protective structures. Before starting covering of the bathing building from within, it is necessary to collect furring on which finishing material will fasten further. Mounting of furring begins with exposure of the top and lower bars. After that by means of plumb or level to wall intermediate members of furring fasten.
Furring has to provide small gap between the lining attached to it and paroizolyatsionny layer.
For fastening of lining it is desirable to use the fastening elements having high resistance to moisture. Application of kleymerov-brackets will be the best decision. In angle joints lining can be cut off on width. Mounting of parobaryer is carried out only in those cases if the bath has been built from the materials not capable to provide normal microair circulation. Therefore for the breathing walls there is quite enough finishing by lining.