Swinging saws belong to high-precision professional equipment. Without this tool it is impossible to provide high-quality joiner's production or construction today.
In fact, it is the small, compact machine in which the circular saw plays a major role. The cutting disk can be replaced quickly, depending on type of the cut material and the required machine cut width. Also the design allows to establish and abrasive wheels. Any swinging saw is based on lever system which provides the deep and equal machine cut under any set corner in both planes. At the same time there is reliable fixing of provision of circular saw. The main feature of this electric tool – the high accuracy of crosscutting of material that, eventually, guarantees high-quality assembly of elements at finishing production phase.
All swinging saws are supplied with the system of protection – the special casing which is not allowing contact of the operator with the cutting disk. As addition, the saw complete set sack for collecting sawdust and clearing of possible sparks is possible. The pendular equipment intends for cutting not only wooden blanks; installation of special disk allows to make exact section of elements from plastic, thin metal or alloys.
The efficiency of cutting and life cycle of the pendular equipment first of all are connected with the power of the electric motor and value of circumferential speed of rotation of saw. The these parameters are higher, the quicker, the machine cut more than the term of operation is more qualitatively made. However there is also other moment influencing the performance of swinging saws – the auxiliary equipment. Modern producers pay much attention to improvement of systems of clip of preparations. Here mobile sponges, folding comb, the screw mechanism belong. Here the main task – creation of such system which, on the one hand, reliably fixes preparation with another – gives opportunity of expeditious movement of the cut part or installation new. When choosing swinging saw it is recommended to lean on type of the main works, material of the cut preparations. If, for example, it is supposed to cut metal preparations in large volumes, then it is more preferable to buy the special equipment intended for performance of this technology operation with metal. The special swinging saw on metal is equipped with special clips and more powerful screw mechanism. Use of the highly specialized electric tool will allow to receive the better machine cut and will increase the term of operation of saw.