Inability of the washing machine to gather water – one of the most widespread problems which people when using such equipment face. The causes of such fault dozens, and some of them only the experienced serviceman can define.
The most elementary options of emergence of such problem – lack of water and the closed crane of its giving in the machine. Not superfluous will be to check similar "trifles", the essence can consist in them. At the same time check whether the water supply crane is serviceable. If you cannot make it, ask for the help the plumber. In case of need the expert will be able to replace the faulty crane also.
More widespread, but not so obvious failure cause is that the door of the hatch is badly closed, or at its zakhlopyvaniye the locking gear does not work. In this case the washing machine "thinks" that the door is open, and does not pump water. This problem is characteristic of old products. In them guides wear out and damaged over time, the fixing uvula warps. At best for solution it is enough to press with force the hatch of the washing machine that all parts have risen into place, and then set of water will begin. However, as a rule, at strong wear of constructive parts of it becomes insufficiently. In that case it is necessary to remove door and to change parts.
If the washing machine does not gather water, and before fault emergence the pressure was very weak, the problem can be that the filter in hose was hammered and does not pass liquid. To check whether all as it should be with grid of inlet valve, it is necessary to disconnect hose and to examine parts then to try to pass water on pipe. If the filter is polluted or water does not pass on hose, will be to clean or replace problem elements enough. One of the most unpleasant and hardly removable problems at which the washing machine ceases to gather water consists in violation of work of programmator. This electronic device – the "brain" of household appliances operating all its "actions". When the signal of need to gather water is not given, the washing machine cannot execute this command. At best the problem consists in burn-out of several contacts. The serviceman of washing machines will be able to eliminate such fault without replacement of part. Another matter if the programmator has failed and it is impossible to repair it. In this case it is necessary to buy new part, and it is fraught with expenses not only money, but also time, especially if it is about repair of the washing machine of rare model.