Vinyl wall-paper has a number of advantages before paper. They are stronger and elastic, are not deformed in the course of shrinkage why they, actually, and are recommended to glue in new buildings. Process of gluing of vinyl wall-paper, besides, is in many respects simpler, than paper that too it is important if it is necessary to be engaged in it independently. However there is also minus: vinyl breathes usually worse, in the room can be excessively damp.
Making out walls, it is important not to forget that it is the most noticeable part of the room, it is necessary to think not only of how it is correct to glue vinyl wall-paper, but also volume that walls looked beautifully.
So, getting to this work, we will correctly prepare a surface as it needs to be made to begin to glue vinyl wall-paper. The wall has to be absolutely equal. From it it is necessary to clean off old wall-paper or paint carefully. They should be moistened with water or special liquid and then to smooth out a wall by means of the pallet. If under old wall-paper some cracks or chips are found, then they need to be puttied. Best of all then to ground walls wallpaper glue.
At cultivation of glue it is necessary to pour it into water gradually: process reminds production of batter. Even to mix, in the absence of a special nozzle on a drill, it is possible just a nimbus, only to buy for this purpose new or to properly wash out this: quite often add something to glue against a mold and insects – it is necessary to think, poisonous.
If wall-paper without the drawing, then they have to be cut only on pieces of the necessary length. If the drawing is, they should be picked up carefully for the upper edge, combining them and cutting off superfluous. Unnecessary it is better to leave big pieces so far: perhaps, they will be useful for some completions.
It is possible to start pasting only after primer completely dried.
How it is correct to glue vinyl wall-paper end-to-end?
This wall-paper quite thick and when pasting with an overlap seams will be noticeable. These ways equally require attention, considering, how well at us quite often build. The insignificant curvature of a wall (not a right angle, for example, between a ceiling and a wall, literally in degree) will lead to the fact that strips will creep away forming a crack. It is necessary to pay to it attention at once and to trim the upper edge of a strip.
If in the instruction it is not told differently, to spread out the cut-off piece of wall-paper the drawing down on newspapers and to smear with glue, using a brush. The new clothes brush is very convenient for this purpose.
Then to put a strip across approximately on a third, to get on a step-ladder, to put the top part, watching that she laid down end-to-end from previous, and to carry out by a piece of pure fabric in the middle of a strip from top to down, and then to the parties as if drawing a fir-tree. It is necessary that there is no bubble left filled with air. Then to get down on a floor, to develop the sprained part of an oboina and to do with it the same, as from top: to paste and carry out by a rag. It is possible to use a clean dry brush, but it will stop being dry and clean soon: drops of glue will inevitably get on it from a joint. A rag it is possible (and it is necessary!) to take then new and where so many brushes you will save enough!? If nevertheless unevenly it turns out, let there will be not a crack, but excess wall-paper it is possible to cut off on a ruler a sharp knife.
On a roll of each type of wall-paper it is specified how it is correct to glue them, but it is necessary to remember that vinyl wall-paper on a flizelinovy basis, as a rule, is glued a little differently. Glue in this case should be applied not on wall-paper, and directly on a wall.
At this time in the room categorically there should not be a draft!
How it is correct to glue vinyl wall-paper in corners?
It is impossible to glue end-to-end in a corner, having bent in half. It is necessary to paste one panel so that about 5 cm were the share of the next wall, and the second panel (on the other hand) – in the corner. Here it is better to paste with an overlap.
How it is correct to paste vinyl wall-paper on a ceiling?
It is necessary to make a marking from a window to an opposite wall. But alone you will not make such work: while one glues the first part of a panel, another holds the opposite edge with a mop.