The electromagnetic impulse of low power is not capable to cause huge destructions, taking down everything on the way, such as, that which turns out as a result of nuclear explosion. It is possible to create a low-power impulse in house conditions.
Instruction
1. For a start get unnecessary you further the film camera, it is desirable, having flash.
2. Put on gloves and start process of discharge of the accumulative condenser of flash. By means of flat-nose pliers with isolation take the resistor on 0.5 W with a resistance about 1 kOhm and close by means of it the condenser for 30-40 seconds. Then close the condenser by means of the screw-driver with isolation for half-minute that it was finally discharged.
3. Track that tension in the condenser was no more than several volts. If it is required, discharge it once again. On conclusions of the condenser make a crossing point.
4. Now be engaged in discharge of the condenser in a chain of small capacity - a sinkhrokontakta. For this purpose reel up about 200 rounds of the isolated millimetric wire on the dielectric coil with a diameter of 5-6 mm. From above cover a winding with an insulating tape.
5. Connect a framework with a winding consistently with the accumulative condenser of flash. In case your camera has no flash check button, then it is possible to connect the zvonkovy button parallel to a sinkhrokontakt.
6. In the case of the camera make openings to remove wires from the button and a framework with a winding. Openings will allow to avoid crossclamping and break of so important wires. Now you can remove a crossing point from the accumulative condenser of flash and assemble the device.
7. Take off gloves and put in the battery camera. Try to turn on it, at the same time turning off flash aside. Wait a little until the condenser is charged, and insert into a framework with a winding the screw-driver with the isolated handle.
8. Carefully, holding the screw-driver that it did not fly away aside, press the button. At you the electromagnetic impulse magnetizing the screw-driver at the time of flash has to be formed.