Section shows that the plane gets to a secant. Distinguish the imposed and taken out section. At production of models of various products carrying out additional settings in COMPASS system 3D LT can be required. In particular, during the work with a subsystem of sections and a subsystem of cuts. The purpose of carrying out this additional control — increase in presentation of ready files of drawings.
It is required to you
- Computer, COMPASS system 3D LT.
Instruction
1. We establish the font size, optimum for designation of sections. It is necessary to choose a font on 1 or 2 numbers bigger, than the font size used for drawing a dimensional inscription. Having chosen the Control command, we turn into "Setting up new documents".
2. Having opened the Graphic Documents group we select the Line of a Section/section item.
3. The "Control of Parameters of New Documents" dialog box opens Here it is necessary to set the font parameter — GOST type B, the height parameter — the italics is 1-2 units higher than already established dimensional inscription. If, for example, for a dimensional inscription you already established value 3-3.5, then for a section font height needs to be chosen equal 5. The "stroke length" parameter receives value of 10 mm.
4. Similar parameters need to be set and having selected the Arrow of a Look item. Perform these tunings and press OK.
5. For new documents the installation of parameters should be carried out anew. Standard parameters are by default set, and the presentation of model is again lost.
6. Here we consider only settings which are carried out in already ready files of the drawing. Also, if to speak about designation of section on the paper drawing, then it is necessary to know that it is designated by shading. If the section is taken out by a separate figure, then and its contour is shaded. At the same time it is important to remember that shading is imposed at an angle 45 ° if lines coincide with a contour of a subject of the drawing, then the corner changes on 15 ° in the greater or lower side.