During a heat and after work at the dacha there is a strong wish to be refreshed, in that case it is better to think up something, than souls are just impossible. Ready designs costs rather much therefore having understood how to make a summer shower at the dacha, it is possible to save properly. There are different options which differ not only in material of production, but also a design. We offer option with which many will be able to cope, even without having experience in building
How to make a shower at the dacha?
For a start it is necessary to decide on the place where there will take place installation. Usually for this purpose use secluded places, but at the same time it should be taken into account that the shower should not be far from the house that in cool day not to freeze. To make a summer shower at the dacha with own hands, it is necessary to prepare the small list of materials which can be found in any hardware store. For work prepare boards and laths from dense wood, self-tapping screws, a hose, elements for fixture and also set for creation of the shower. It is necessary to begin with the drawing which will become a basis for future work. It is necessary to apply all sizes on it.
As most to make a summer shower at the dacha:
- In the presented master class the pallet will have the circle form, but if desired you can make it square. Take cardboard and, being guided by the desirable size, draw with big compasses a circle. Then in it draw 2 squares, as shown in the drawing. The pencil attached on thread can serve as compasses. Take four boards which have to be a little more parties of the entered square. Apply them to its parties (see the drawing) and by means of compasses transfer a circle to boards.
- The next stage in business which concerns as most to make a shower at the dacha – using the electric fret saw or a usual saw, make cuts on the specified lines. To make the second layer do the same actions, having taken four more boards. After that all did, it is necessary to connect self-tapping screws, previously having drilled openings. For this purpose put two circles so that two squares were displaced by 90 degrees. That it became clear, you watch the drawing. One more important point – needs to be determined fastening for the pipe pumping water. One should be fastened on the first layer of boards, and the second – on top. Everything is shown in the drawing.
- Apparently, after connection of two layers, triangles in which form it is necessary to cut out figures from new boards were formed. They also should be fastened self-tapping screws. Establish a support for a pipe, having attached it self-tapping screws between fastenings. Do not forget to make previously above an opening for connection of a hose. Close fastening a wide board, having cut out in it a groove that will serve as protection against water ingress on fastenings which can rust as a result of it.
- Cover the remained area of a pallet with laths, without forgetting to leave between them the gap necessary for a water drain. You fix their self-tapping screws. It was necessary only to cut off boards to receive ideally round pallet.
- Understanding how it is correct to make a shower at the dacha, it is possible to pass to installation of a pipe. In shops of plumbing it is possible to buy special set which includes a curved pipe, the mixer, the adapter and a bracket. Attach a pipe to a support and already in it fasten the spray. It will be necessary only to attach the mixer and the adapter. It is necessary to bring a hose which will pump water to the adapter. That's all, the shower is ready.
If you want to add side overlappings, then it is possible to use two options. It agrees to the first, walls are made of a tree on legs which are implanted then around already ready shower separately. The second option – can be made of pipes a square and to attach it from above to a support, and already on it to put on a curtain rings.