To the person there can be absolutely different situations, for example, keys from the car were lost or they were broken. If there is no time for causing service and to order new keys, information how to start the car without ignition key, will be very useful.
As thieves use similar councils for stealing of cars, many producers modern cars apply different cunnings to secure owners of vehicles. The way given below will be suitable for the models produced to the middle of the 90th.
How to start the car without key by connection of wires?
In some models of modern cars there are special protective mechanisms which, in attempts to start the car without key, block the starter, and already nothing to make without experts it will not turn out. Therefore do not use this method for modern cars. It is recommended to look at the instruction and to be convinced that there is an access to a steering column and the switch of transfers.
We pass to the instruction, the yak to start the car without key:
- It is necessary to remove a cover which is on a steering column. If it is impossible to unscrew bolts, then it is possible just to break pins, usually it acts on older models of a car.
- After that you will see an interlacing of different conducting. It is necessary to choose from three main bunches that which goes to the battery, ignition and the starter. It is directly in the top part of a steering column. To define what color of a wire corresponds to the ignition key, read the instruction or look at information on the Internet as different producers can use the colors. In most cases the wire necessary to us red, but is the best of all to make sure of it.
- The following step to instructions As it is possible to start the car without key, means stripping of isolation on battery wires. It is necessary to clean about 2.5 cm. Wind them surely with an insulating tape that there was no short circuit.
- Connect a wire of inclusion of ignition and the battery. During it have to earn electrcics of a car. To start the engine, it is necessary to create a spark on a starter wire. For this purpose on 1 cm it is necessary to bare the wire which is responsible for it. Accurately touch them a battery wire that the spark appeared. Act carefully as there can be an electric shock.
- After that it is necessary to accelerate the engine idling. If not to make it, then the car will die out, and it is necessary to repeat process one more time. Isolate wires and remove them. It is possible to begin the movement to muffle a car, just disconnect a wire of ignition and the battery.
Interests many whether it is possible to start the car a key without chip which is used in modern foreign cars. Perhaps, quirky thieves also have some techniques, but they are confidential. Production of the duplicate without chip will only allow to open a door, and to here get a car it will not turn out. In that case it is worth or addressing to salon where a car was bought, or to look for firms which have programs helping to restore the chip.
How to start the car with an immobilizer without key?
Situation, of course, difficult, but also it is possible to cope with it. If you lost only one key, then it is possible to get the chip from another and to attach it to the immobilizer antenna on the ignition lock. Similar manipulations will lead to the fact that the device will be switched-off when any key is inserted into the ignition lock. There is more difficult option – an immobilizer round. For this purpose it is necessary to understand the electric circuit of the car as the device can block several chains at once thoroughly. The task is in finding a way on which it is possible to give tension directly.