Windows from PVC win the increasing and great popularity. This fact very simply speaks: they are available at the price, but at the same time are reliable, durable and convenient in operation, perfectly keep heat. However over time the accessories on double-glazed windows can weaken, they will be worse closed, allowing emergence of drafts. But not all house owners know how to tighten plastic windows that did not blow. Though it is not so difficult to make it, having repaired the hands.
How to tighten plastic windows: general recommendations
For a start it is necessary to pick up suitable tools – the most usual which are in an arsenal of any house master: key hexagon (4 mm), cross screw-driver (No. 3.4), passatizh or flat-nose pliers. It should be noted that most often there is enough one key, but also other objects can be necessary depending on complexity of repair work.
That whom the question interests how to tighten plastic windows that did not blow, it is necessary to know that if it is breakage rather serious, for example, the shutter was deformed or sealant wore out, then to eliminate with the hands it it will not turn out. And here if the clip of a transom weakened and from under it noticeably pulls a draft, then it is just simple to correct this defect: it is necessary to adjust clowns. They are located on a frame contour and when it is closed, they have to get up on the places allocated to them. If it does not occur, then the key hexagon or flat-nose pliers will help to adjust them. Also leaky adherence of a shutter can be caused by the shift of levels – on them it is necessary to tighten screws by means of the screw-driver. It is expedient to perform similar operations in anticipation of a winter season. It is better to leave a small gap in the summer to provide natural air flow outside and good ventilation.
How to tighten loops at plastic windows?
One of the main problems with which owners of rooms face the PVC windows it is a distortion and sagging of shutters. They begin to open, cling worse the upper or bottom edge to a frame. In this case it is necessary to tighten loops at plastic windows, and the crack between details of a design will disappear.
To adjust loops only in the top part, it is more convenient to turn a transom to position "airing". Further it is necessary to use a key hexagon to tighten the screw – it it is necessary to turn clockwise on 1-1.5 turns. To adjust the lower loops, the window needs to be opened completely, to remove from them a slip, and then, using the same key, once clockwise to turn the screw. If you noticed that the shutter touches a side part of a frame when closing and opening, then it is necessary to tighten both loops at the same time. Openings through which adjustment can be executed are for this purpose used, without touching protective plastic caps.
How to tighten other accessories at plastic windows?
That the window from PVC of a profile opened well and closed, did not jam that it from under it did not blow, it is necessary to pay attention not only to loops and clips, but such fitment element as the handle. That who is anxious with a problem how to tighten plastic windows for the winter, it is necessary to adjust the become loose lock uvula if it is – by means of the same six-sided key. To tighten the handle, it is necessary to remove from it a kick plate and the screw-driver to adjust screws. If the handle jams and badly turns, it should be oiled lubricating, the Detail needs to be removed, wiped, to clean the released opening from the collected dust, to sink there oil, to insert back the handle and properly to fix it.
"