The radar is an electronic device of the traffic police officer which shows the speed of the cars passing by it. At violation of the high-speed mode, troubles and penalties are possible. And, of course, the motorists discordant with actions of traffic police officers began to install on own cars the electronic systems – radars detectors which catch frequencies of signals of the police radar and report about it to the owner of the car. And that reduces speed to an admissible mark.
Instruction
1. For work just connect the radar to a lighter nest. But many motorists do not accept existence of excess wires in salon therefore they turn on the radar in the car electrical system in other ways.
2. As food on the radar has to move only at the included ignition, it can be powered from lighting of the car. A point most convenient for this purpose is the lamp in a glovebox.
3. Suspend the radar on a bracket at a rear-view mirror, lay the feeding radar wire under a ceiling covering to the right (just put it in a crack at a windshield and strengthen foam rubber pieces).
4. Remove a plastic slip on the right on a rack of a windshield and stretch a wire between a face of the front panel and a body under a glovebox by means of a broach (thick single-core wire) down.
5. Reach the left hand from below up under a glovebox and grope its lamp. Press a lamp latch at the left, move it in a glovebox. Disconnect the lamp socket, remove the lamp and fasten to it is red \white "+" to a wire a wire "plus" from the radar. Put on the lamp socket a wire.
6. The wire "minus" is on the socket of the button of switching off of the lamp of a glovebox. Grope on the right side on the lower back wall of a glovebox the socket and disconnect it. Find a tester "minus" a wire, connect it to radar "minus".
7. Check operation of the radar, turn on the engine and make sure that the radar is switched on. After engine shutdown the radar has to be switched-off. Collect the glovebox lighting system upside-down.