As finishing material for the bathroom and kitchen the tile most often is chosen. It has many advantages and first of all it concerns moisture resistance. It is possible to cope with work independently for what it is necessary to know how it is correct to put a ceramic tile. Use it for finishing of a floor and walls, at the same time everyone option has features.
How it is correct to put a tile on a wall in a toilet?
It is necessary to begin with preparatory work. By means of plaster level a surface and process it primer. Previously calculate necessary quantity of a tile, trying to use as little as possible the cut-off pieces. In the bathroom usually stack a tile only on a working surface.
As it is correct to put a tile:
- Laying should be made from below up and it is the best of all to begin with the second or third row if you put further a tile on a floor that it blocked a wall. If is not present, then begin with the bottom.
- Make horizontal and vertical tags and on them pull a beacon-type cord or draw a continuous line.
- Prepare glue on the recipe submitted on packing and impose it on a tile, using the gear pallet.
- Establish the first tile on horizontal and vertical marks from a corner and continue a laying. Leave space between tiles, using special crosses that seams were identical. Spread the cut-off tiles right at the end.
- Use level and also you watch that edges coincided with beacon-type structure. You look at a reverse side of a tile where the arrow specifies the direction of laying.
- Consider that it is possible to adjust placement of a tile only for 15 min. after it is established into place, and then, glue stiffens and it is necessary to remove it completely and to put a new layer.
- Start a finish, choosing it under color of a tile. Use for this purpose the special rubber pallet. In end wipe a surface a damp sponge.
How it is correct to put a floor tile in the bathroom?
There are three standard options of laying of a plate. It is possible to lay everything direct ranks, that is seams a number of the lying tiles have to coincide. The second option – "in a break off", that is seams of the top row have to be placed over the middle of the lower tile. Still it is possible to stack a tile on diagonal, that is a laying not vertical, but horizontal. It is the most difficult and uneconomical option.
The surface has to be leveled and it is checked by level. It is obligatory to progruntovat it, for the best fastening of a tile. For those whom interests as it is correct to begin to put a tile in bathing or other room, It is necessary to tell that it is necessary to begin with a marking and with calculation of necessary amount of material. For a basting of center lines, use the ropes rubbed with chalk which need to be put to a floor. Just it is the best of all at first to spread out a tile to be convinced that everything is picked up correctly.
As it is correct to put a sexual tile:
- It is necessary to begin a laying with an integral tile from a corner, opposite to an entrance. Apply glue on a floor on the site no more than one square meter. Level it, using the gear pallet.
- Put a tile, knocking on it with a rubber hammer, and level its situation, using level. Lay the second tile, dividing seams special crosses. Surely check everything level. If excess glue sideways got out, then it is recommended to be removed.
- Stack the cut-off tile right at the end. Leave everything for day, and then, remove crosses and jam seams. In completion of work wash the floor.
"