You should not hurry and carry on garbage can the chairs which have lost the original form, or simply ceased to fit into interior of your dwelling. There are several ways of "return to life" of old, ragged furniture.
It is required to you
- - fabric;
- - decorative cord;
- - scissors;
- - safety pins;
- - roller;
- - tapes;
- - small feather pillow;
- - needle;
- - threads;
- - elastic band;
- - scarfs with motley ornament;
- - decoupage card;
- - brushes;
- - PVA glue;
- - acrylic lacquer.
Instruction
1. Carefully measure the roller. Cut off necessary amount of fabric by means of scissors, leaving allowances of 30 cm longwise, 2 cm - on width. Envelop fabric around the roller and record edges by means of decorative cord. Take the feather pillow suitable by the size sitting of chair and sew tapes to its corners. Tie them around chair legs, having recorded pillow on sitting. Lay fabric on chair so that it concerned floor. Straighten drapery and slightly tuck in it under pillow. Fix material by means of safety pins. Collect fabric in sockets on the angles of sitting, having fixed it by means of elastic bands. Collect the surplus of fabric formed in the lower part of chair from back. Create the socket and fix it elastic band. Round off corners of drapery and accurately trim the edges of material. Lay the roller on sitting of chair.
2. For drapery of this type it is necessary to take silk fabric. Lay material so that the chair has been completely closed. Delay two face angles of drapery a little and, having crossed them, record on opposite legs of chair by means of elastic bands. Lay the fabric lying on chair back, folds. Tuck in it under sitting of chair a little and fix by means of safety pins. Take two scarfs, put in half and fasten among themselves so that they have formed cross. Put the received design on chair back so that the position of joint of scarfs was strictly on the middle. Attach scarfs to drapery by means of safety pins. Connect the ends of scarfs among themselves, on each side chair backs.
3. This option of decor will be suitable for chairs with rigid continuous sitting. Take decoupage card and cut off it in form of sitting of chair. Ground surface by means of PVA glue. Slightly humidify and accurately paste decoupage card on sitting. You watch that there were no roughnesses and bubbles. Put two layers of acrylic lacquer.