The railing are rather widespread kitchen accessory. The railing not only are convenient and functional, they give to any kitchen modern look, allowing to place necessary utensils near working surface.
- - fixing set;
- - drill;
- - level;
- - tape measure;
- - marker.
1. Screw hexagon which is included in the fixing package of the railing, small small screw in the body of the holder of the railing so that the railing freely moved in the holder. Twist the second small screw in the basis of the holder so that he freely put on on the sleeve which will be fixed by screw on wall. Screw small screws in all holders, on two on the holder in the same way.
2. Insert the railing in holders and tighten the small screws holding the railing in the holder. When mounting these small screws should not be noticeable, i.e. have them below. It is necessary to consider number of the moments before holders are finally fixed on the railing, and you start marking. The stub will be put on edge of the railing, hooks can put on on the railing not later, and in the course of installation of the railing, places of joints of reyling have to be located in the holder in case the railing compound or kitchen angular. According to it, define the locations of holders on the railing. Tighten holders on railing tube.
3. Define railing distance from table-top so that on it it was convenient to place kitchen utensils. Circle the basis of the extreme holder with pencil or marker. Drill opening in wall or if the wall panel, then at first in it, and then in wall by drill on concrete with a diameter of 6 mm is installed. Hammer dowel into opening. Fasten screw the holder's sleeve.
4. Dress the extreme holder on the sleeve. The second end of the railing is free. Using ruler or tape measure, install the railing parallel to table-top. In such situation circle the following holder. Drill the following opening and so on, establishing to holders into place.