The boat flat-bottomed boat can be used differently. It is necessary in the economic purposes, in backpackings, on fishing. Such boat has quite simple design. At its storage there are no problems.
It is required to you
- To make the boat flat-bottomed boat, it is necessary to have:
- 7 pine boards which thickness is 15-20 millimeters width of 300 millimeters, and length – 5 meters
- 3 pine boards which thickness of 50 millimeters, width is 300 millimeters and length are 4 meters
- Pine board of 30x200 millimeters.
- Two veneer sheets which thickness is 3-5 millimeters
- 1 kilogram of oil paint
- 3 kilograms of whitewash on natural drying oil;
- 5 kilograms of nails 50 millimeters long;
- 1 kilogram of screws 50 millimeters long.
Instruction
1. At first frames are made. They have to be 200 millimeters higher than board level. Also surely the stem and tranets becomes. Their installation is made on keel board which has the size of 50x20 millimeters. Fastening is carried out by nails. Between frames benches have to be established. They also fasten on nails. The upper part of frames, stem and tranets fastens to side adjusting board which sizes are 20x200x5000 millimeters.
2. Something similar is formed on timbering which is fixed the main form of the boat. After work is finished, nadustanovochny boards are removed. Also it is impossible to forget about excess 20 centimeters of frames. They have to be sawn off. After that the lower onboard boards are beaten. The lower contours have to be cut accurately off by saw.
3. At the next stage the top onboard boards have to be attached. The keel board has to be torn off, and on its place the bottom board has to be beaten. Then 3 false keels on lines of connection fasten. Thus, the best splice closure is reached. Joints have to be well caulked by tow which is moistened in drying oil. Also it is impossible to forget about putty and cleaning by abrasive paper. After all this the trunk becomes. Most often it is done of plywood. The best place for trunk the nasal part of the boat is considered. Under average bench the cage for fish is placed. After that painting works are performed. Paint usually in two-three layers. The oil paint is used.