The Swede is heating furnace and kitchen stove together, its sizes, as a rule are 102 cm x 77 cm x 201 cm. Similar designs are very popular among summer residents who put them independently.
Instruction
1. Put the Swede in 22 brick rows according to the following plan. spread the 1st row and the 2nd row from brick halves. After have laid the 2nd row, put podduvalny door and fix by the 3rd row. Surely leave window.
2. Start the 4th row - it is oven support. The oven before installation needs to be strengthened from three parties iron. It is necessary to impose with layer of refractory brick part of oven from that party where there will be toplivnik. the 5th row blocks podduvalny door and prochistny window. Cover grid iron refractory brick. Establish furnace door on the 5th row too, and fix by sixth row also it, and oven.
3. ""on edge"" impose with the 7th row oven walls. make the 8th row on an equal basis with furnace door. For overlapping of door in the 9th row the steel strip is necessary. Impose clay mortar on oven and put plate.
4. the 10th row begins dymooborot laying. For clearing of the first turn the window is left. the 11th row prokryvatsya window of the first turn and two new windows are formed. They will serve for cleaning of channels and removal of soot. Now lay two steel strips in 20–25 cm. It is support of internal walls.
5. Windows of cleaning of channels will be blocked by the 12th row. After it height of brick wall of the furnace will reach the top point of door of the cooking chamber. Record wire between the 12th and 13th ranks. It fixes also door frame. Bricks of the 13th row are laid on edge and form sidewalls of steam-collecting cap. On the 13th row put solution, and on it steel corner and steel strip.
6. Begin the 14th row which forms box of guard and sidewalls. It blocks the cooking chamber. and 1b-y ranks - spread the 15th in the normal way, and on the 16th row put the sheet of roofing steel of 300 mm x 280 mm. the 17th row gives all the best the current poryadovka.
7. During laying of the 18th row leave cleaning window. Bricks are again laid flatwise in the 19th row and further. Because of it the layer will act outside and inside on 30 mm. the 20th row outside too does ledge. With edge on it the steel corner and in the middle steel strip is imposed.
8. the 21st row block dymooborot and form ceiling of the big small stove. Steam and smoke latches are established in this row. the 22nd row begins furnace neck. The laying of oven neck should be conducted taking into account reduction of flue. Flue section at the level of the 22nd row is equal 260 mm x 260 mm, further before pipe decreases up to 130 mm x 260 mm. The furnace is ready.