How to correct without access to network?

How to correct without access to network?

How often modern users of computers and laptops face failure when it is impossible to go on-line, understanding that only several minutes everything perfectly worked. At the same time on the taskbar, the badge of the Internet, but with a yellow triangle and the exclamation mark is below visible on the right. If to guide at it the cursor of a mouse highlights an inscription Identification … Without access to network. It turns out that the network is, but without Internet access how to correct current situation, many Internet users ask a question.

The network is identified, but there is no Internet access what to do?

So, the user, for example, has a brand new laptop which he bought quite recently. Also it connected Wi-Fi with the Internet which the above-mentioned user with success used by means of phone. But at the first inclusion, it is found out that it has an Internet without access to network and what to do in such situation he does not know.

One of the reasons – failures in work of provider. Try to reboot for a start the modem (switch-off it for 10 seconds) if there is no modem, then restart the network adapter and reboot.

How to correct without access to network?

As a rule, such situation occurs in case the user reinstalled the Windows operating system, at the same time installed drivers not original, from some pack ice or from the piracy websites. Usually it happens to users of laptops and netbooks. To these devices it is sometimes very difficult to find original drivers.

Settings of network connection vanish in the brand new Windows system. Therefore it turns out that connection to the Internet is, but without access to network.

  1. To check settings, it is necessary to come into Network and Sharing Center.
  2. To find the Change of Parameters of the Adapter tab and to open it.
  3. To find the adapter in the appeared list and to choose it – either Wi-Fi, or Ethernet. Then to choose its properties then in properties of the adapter to choose properties of the protocol, further it is necessary to open the Properties tab – the dialog box will be highlighted.
  4. Here it should be noted ticks two points where the address and the server automatically.
  5. Also surely it is necessary to be convinced that the automatic mode is chosen. Then the computer or the laptop need to be rebooted.
  6. Then at the subsequent connection of the laptop to the Internet no problems should arise.

Author: «MirrorInfo» Dream Team


Print