The popularity of the built-in equipment increases day by day. Dish washers and fridges have hidden under the decorative panel for a long time, working at the same time for interior of kitchen. Kitchen stoves do not lag behind too: in the market of household appliances the positions increase the built-in cooking surfaces, in particular, gas.
It is required to you
- - tape measure;
- - pencil;
- - ruler;
- - fret saw;
- - heat-resistant glue;
- - brackets;
- - flexible steel hose or pipe;
- - keys.
Instruction
1. Define optimum location of gas cooking surface: on both sides it has to be surrounded at least with small zones of table-top (from four centimeters). If the built-in cooking surface is thinner than table-top, under it the washing or dish washer (between them place layer of the heatreflecting foil) can be established.
2. At the same time the neighbourhood of cooking surface with the fridge is undesirable: heat from rings will destroy heat-insulation layer of the fridge over time. Therefore minimum admissible distance between the built-in cooking surface and the refrigerating unit makes fifteen centimeters.
3. Unpack cooking surface and check integrity of the product delivered to you. Make sure that there are no dents, cracks and chips.
4. Attentively measure the sizes of gas cooking surface then transfer them to table-top. Then by means of the fret saw cut in table-top opening on the planned contour, receding at the same time inside on 10 mm.
5. For prevention of deformation process cut heat-resistant glue. After it by means of special brackets fix gas cooking surface on table-top.
6. Make sure that gas pressure in the pipeline corresponds to requirements of the established cooking surface. After that connect the cooking unit to gas pipe-line. It is possible to use at the same time flexible steel hose or nonflexible pipe.
7. If the cooking surface is connected to gas pipe-line by means of flexible tube, are not carried too far hose and its contact with plate. At connection by means of steel pipe the L-shaped union and special laying are used.