It is difficult to provide door without handle unless it will be door of sliding type in shopping center or other populous place. The doors established in apartments and houses provide handles therefore house masters have to know how to build in this element at door.
It is required to you
- - tape measure;
- - pencil;
- - screw driver;
- - fastening elements;
- - electric drill;
- - special nozzles;
- - chisel;
- - mall;
- - hacksaw.
Instruction
1. The sequence of installation depends on type of the used door handle. Cut-in and laid on handles are considered as the most widespread today.
2. Installation of the door handle of laid on modification does not cause difficulties. It is screwed simply by means of fastening elements on door cloth (do it from two parties and at the identical level).
3. Slightly more difficult mounting of the door handle of cut-in type looks. First of all apply the handle to door cloth and plan its future location. At the same time at face of door cloth note the place where the latch will be established.
4. Install ring drill in electric drill and drill deepening on mark in face. After that apply latch to face (it will allow to make sure that the drilled hole corresponds to the sizes of that part of latch which will be hidden in door cloth).
5. By means of mall and chisel on the planned notches give to deepening the correct form. Blows have to be accurate and easy. If not to calculate force, the door cloth can crack.
6. Insert latch into face opening and apply handle axis. If the axis was too long, truncate it to the necessary sizes, using at the same time hacksaw.
7. Fix latch by the special anchor screws going complete with the door handle of cut-in type. After it insert axis and put on door handles from two parties then fix front plates of handles by fixing parts.
8. Close door and in the place of contact of latch with door case make notches. Then by means of special nozzle drill small opening (by the sizes it has to correspond to laid on plate). After that apply plate and record it on door case by means of anchor screws.