At new plastic windows often there are stickers protecting them in transportation time from scratches. After installation of windows of sticker become unnecessary, moreover, they spoil exterior of the room. For disposal of them there are several ways.
It is required to you
- - peanut butter;
- - liquid for washing of glasses;
- - palette;
- - alcohol, gasoline, white spirit, acetone;
- - hair dryer;
- - special cleaner;
- - rags.
Instruction
1. If windows have established less than a month ago, then process of their cleaning of protective film will occupy time minimum. Just pick up nail tip of adhesive tape and pull for it. The tape will easily depart, without having left glue marks on plasticity.
2. If for any reasons you could not in time to remove film from windows, then for simplification of process use peanut butter. Apply oil on stickers. Wait 10-15 minutes. By means of the wide palette carefully remove film from windows. Instead of clean peanut butter you can use any product or cosmetic cream which part it is. In this case among other ingredients Peanut oil (peanut butter) has to be specified. It is longer necessary to keep foodstuff or cosmetic creams (30 minutes) since concentration of oil in them less.
3. Spray on stickers liquid for washing of glasses. In a few minutes purify plastic by means of the palette, plastic or wooden ruler. Remove residues of glue on profile by means of liquid for removal of varnish, acetone, white spirit or gasoline. For a start test these liquids on the imperceptible site since they can cause turbidity and dullness of some types of plastic.
4. Take the hair dryer for drying of hair. Include on the maximum power and direct current of air to the small site of sticker. When under the influence of heat glue melts, unstick protective film so as far as you will be able. Gradually warm up other sites and clean them the same way. If you have no hair dryer, then be engaged in cleaning of windows in hot summer day. Glue under film will heat up under beams of the sun. And you will be able to remove its remains after removal with normal alcohol.
5. Get in hardware store or the producer of plastic windows has special cleaner, for example COSMOFEEN. The digit in the name of cleaner (5, 10 or 20) indicates concentration of active agents in solution. Apply solution on sticker, and then purify plastic by means of the palette. Then again walk on profile the rags moistened with cleaner. Thanks to the fact that it dissolves top layer of plastic small scratches on profile will disappear, and the window will look as new.