The alarm system of the car is the difficult electronic device and as any other device, it periodically fails. If your car alarm is on after-sales service, for debugging in its work it is recommended to address to the service center. If the guarantee for the device has already ended, then it is possible to try to establish the reason of breakage and to eliminate it independently.
It is required to you
- - screw-driver;
- - nippers;
- - insulating tape;
- - bulb on 12B with the soldered wires.
Instruction
1. The alarm system does not react on brelokakkuratno turn off the self-tapping screw on back cover brelka by means of the cross-shaped screw-driver. It is recommended to do it on plain horizontal surface not to lose small parts. Sort charm and replace the battery which is in it. Can demonstrate that the battery is discharged dim luminescence of the LED which is in charm and reduction of range brelka.
2. The LED burns brightly, but the alarm system does not react to pressing of buttons of brelkaodn from possible the reason of this malfunction that AOS representing the minicomputer "has hung". For reset of AOS and return it in operating mode it is necessary to remove any terminal from the accumulator, to wait some time and then again to put the terminal into place. Press the button brelka and check operation of the alarm system. If the alarm system works normally, fix the terminal. If the problem remained, try to repeat this operation 2-3 times.
3. Power supply to signalizatsiiproverta availability of the wire with the hinged safety lock going from the "plus" accumulator terminal was gone. If this wire is available, check condition of the safety lock. If necessary replace it. Check operation of electric devices of your car. In case of fault of devices check and if necessary replace regular safety locks. Define what of supply circuits is broken. It is possible to make it by means of "ring-up". Restore the broken supply circuit, having tightened the weights self-tapping screw or having replaced safety locks.