The quality of sound path in many respects depends on connecting cable, but dishonest producers, as much as possible praising highly the goods, offer to sale acoustic cable at the excessive price. Therefore recommendations how to unsolder cable independently, will allow not only to improve sound quality, but also to save.
Instruction
1. Come into shop of radio components and get three meters of cable, already at home prepare the soldering iron. Further you should perform the following operations, unsoldering the acquired cable independently. First, spread out on work table the acquired cable, two Jackie, model or any other sharp knife, solder and the soldering iron, and then follow the instruction, carefully observing its sequence.
2. At first pick up the bought cable and very accurately cut off two centimeters from the general isolation so that the braid has become bare. Then very slowly and carefully untwine braid up to the line of sawn-off shotgun executed by you. After you execute this step, surely cut off internal isolation at distance about one centimeter from its edge. Secondly, shift the braid of your cable untwined earlier around its internal isolation to one of the parties, and then correctly twist in the form of normal wire. Then, to unsolder cable, vein from braid and the central vein carefully to zaluzhivayta.
3. And also on wire, put on two thermoshrinkage pieces, different in the size, the central part, at the same time the big piece has to be not less than four centimeters, and smaller – only one centimeter. When braid already well of proluzhen, cut off it, getting rid of all superfluous, further impose it on external contact of the prepared Jack with clip and solder. Wishing to unsolder acoustic cable, weld center conductor on the turned-out part. Pull thermoshrinkage to the place of soldering of wires, warm up it so that thermoshrinkage uset to the necessary size, and the place of soldering has been well insulated.
4. It is a little more, and the cable will be ready. Only correctly clamp external contact of Jack so that it could hold rather strong wire, then densely pull on it big piece of thermoshrinkage which needs to be put on wire in advance. Further seat him the same actions, as well as the previous Jack. Wind on it Jack's cap, and then repeat similar actions since the return end of cable. You remember at the same time that the great value has focus of wire therefore use thermoshrinkage of different colors for the different ends of cable that subsequently to mix nothing.