The fishing hobby is one of expensive hobbies. Because good baits, quality materials and tackles cost much. But not always even the most expensive leads are the most efficient. The solution of this problem - self-made leads from a guitar string.
It is required to you
- Guitar string No. 2
- Flat-nose pliers
- Vertlyuzhok
- Thick pricker
Instruction
1. In the beginning it is necessary to take a string and to wind it around a pricker or a steel rod (it is possible to use also a thick knitting needle). Thus the top round ringlet becomes.
2. Then it is necessary to twist a string. Both durability of a lead, and speed of replacement of a bait depends on quality of twist. The correct twist has to be such: the main piece of a wire and side svivatsya symmetrically. At all not to a svivayta a string so that the main piece remained direct, and other end of a string was just wound around it. At such twist durability will be lower, and it will be more difficult to replace a bait.
3. After the first loop with a tail is ready, the string needs to be developed back, and to cut off a direct ""not curled"" tail so that at the subsequent twisting the string was completely wound on the main core of a lead.
4. The second end of a lead needs to be made in the same way, but after untwisting to insert a vertlyuzhok into a ringlet and to record it there. For durability the turning with a vertlyuzhok can be pressed out flat-nose pliers several times.