This jet plane sharply soars up. Therefore start it on the street, far from people. Paint it brightly that it was easier to find.
It is required to you
- - transfer paper
- - adhesive tape
- - pencil
- - ruler
- - office paper clips
- - eraser
- - thin strong cardboard
- - 6 rubber rings
- - scissors
- - ball pen
- - shoe knife
- - straw for cocktail
- - thick needle
- - felt-tip pen
- - PVA glue
- - two pins
Instruction
1. Copy on cardboard blue lines once, and red - two times. Cut out. Do not cut on dashed lines.
2. Press through one keel along a dashed line. Impose a ruler along the line which should be pressed through. With pressing carry out on the line by a ball pen. Turn the second keel and too press through. Turn the plane and press through between cuts of ailerons. Bend keels along the pressed-through lines.
3. Stick together together the unbent parts of a keel. Paste a keel to the plane on the central line, as shown in the drawing. On each side paste a keel tail to the plane an adhesive tape. Unbend ailerons up.
4. Copy and cut out a nose. Paste it on a layer of an eraser 1 cm thick. When dries, cut off an eraser a shoe knife on a nose contour. Turn.
5. Cut off a piece of a straw 2 cm long. Tolstaya a needle pierce a hole in an eraser.
6. Densely insert into a hole of cuttings of a straw. Take out, dip into glue and insert again. Let's dry.
7. Paste an eraser to a plane nose strong glue. Grease with glue of an edge of two thumbtacks and press them into an eraser on both sides of a keel.
8. Start of the plane. Spread out six rubber rings in pairs. Wrap up one couple around a pencil, pass throughout yourself and hardly tighten.
9. String other couples to make the long film. Hardly tighten knots. Holding the plane in one hand, pass a straw for cocktail through the end of a tape, pull very strongly and release.