Cesspools in the wooden street toilets which are brought down from boards at the dacha remain in the past. Today it is possible to make of inexpensive modern materials the convenient system of the sewerage with toilet bowl and shower cabin in the house and with drain hole out of it.
It is required to you
- Concrete or cement, bricks, automobile tires, concrete sewer rings, sewer cover or the hatch, sewage plastic pipe with large diameter, two bags of gravel or crushed stone, toilet bowl.
Instruction
1. Define where at the dacha you will be able to allocate the space for bathroom. Have at the same time in mind that (septic tank) you will need to make sewer hole for sewage disposal behind the house as it is possible closer to the room where there will be toilet bowl. Have hole in the place which the assenizatorsky machine for pumping of drain waters will be able freely to approach. The septic tank has to be from point with potable water (columns, well, the well) at distance not less than 30 meters.
2. Prepare septic tank on the site of the dacha. It can be made various methods: - to dig out hole 2х2 m and 3 m wide in depth, to concrete it on the walls; - in round hole to put 3-4 concrete sewer rings (the hole is prepared under the size of concrete ready rings); - in round hole to put the used tires from the car in any quantity and to fasten them among themselves with sealant; - to impose the dug-out hole with brick with cement laying. The bottom of any hole chosen by you should be filled up with crushed stone or gravel.
3. Dig from hole to the house trench of 1 m in depth (for opposition to freezing of waste waters) in which the plastic sewage pipe will be laid. Try to stack pipe with the smallest quantity of bends that less blockages in it were formed. The sewage pipe has to lie from the house to hole under bias that water on it flew down quickly and did not freeze if you live in the country in winter time. The pipe on the street should be covered with earth, and in the house to decorate at discretion.
4. Connect to pipe toilet bowl, sink and other water points which have been provided by the system of water supply and drain in the house. Check how the system adjusted by you works. If everything is all right, close septic tank special cover or the hatch that was not from smell hole.
5. At installation of toilet bowl in order that water was drained on system without difficulty, establish air valve for ventilation of water waste system. It is required to be established on the highest point of all sewerage in the house. The fact is that water involves air, than forms reduced pressure in pipes which holds at the same time water. The valve, cheap at cost, will level this pressure in system and stabilizes good operation of the sewerage at the dacha.