Modern production of tile is quite difficult technological process where at each production stage it is necessary to follow accurately technology how to do tile for wall decoration and floor. That the tile conformed to standards, carefully observe full cycle of its production, doing not pass any important point.
Instruction
1. Analyzing technology, how to do tile, you remember that now the enameled tile is most demanded therefore you make this type of facing material. At first prepare clay in office of massozagotovka and significantly to reduce temperature of its melting, surely add plavna. First, miss the received mix through number of special sit that allows to eliminate quite large particles which in ready tile are considered as defect. Then evaporate water from the turned-out mix that press powder of the structure set by you as a result has turned out.
2. Secondly, production technique of tile provides pressing of the tile, at the same time use special stamp which allows to make ravnoplotny tile. You make tile of ideal geometrical parameters and you monitor its absolutely identical shrinkage. After that, so the tile is pressed, dry it within two hours so that to reduce contents in moisture product to 0.2%. Well blow off dust from the dried-up tile, then carefully moisten tile with water and cover with engobe – special substance by means of which coupling of "crock" of tile and the enameled glaze is reached.
3. The further cycle of production of tile provides qualitative putting enamel therefore you apply on tile "crock" layer by layer the glaze creating the original drawing, and then fix it by fixative. After you have put all layers of enamel, process the made tile special material for the purpose of increase in its wear resistance, and after dressing send tile to the furnace for its subsequent roasting. You remember - that the tile has not cracked, original temperature in the furnace has to be 60 °, and only gradually heat it till 1250 °.
4. Having warmed up tile in the furnace up to the maximum temperature, sharply cool the made product, and then carefully check quality of the made tile. So, test the turned-out tile for durability, creating pressure in 38 kg/cm2, and after that send all tile which has not broken up from high pressure, into the subsequent sorting. Remember that modern production techniques of tile provide not control of the made products by method of visual inspection, but also thorough computer control in the electronic way.