It is not so difficult to execute electrical wiring of the house or at the dacha. It is enough to have some normal tools and suitable wire.
It is required to you
- Duplex wire, knife, hammer, nippers or flat-nose pliers, indicator screw-driver, insulating tape.
Instruction
1. At construction of the new house or apartment renovation there is need for laying of electrical wiring. Sometimes happens it is necessary to install the additional socket or to move already existing socket to other place, to connect the bought lamp, sconce. To lay in this case wiring not so difficult as can seem in the beginning. For this purpose we need duplex wire, knife, the hammer, nippers or flat-nose pliers with cutting edges and the indicator screw-driver, insulating tape or caps, brackets for fastening of cable – depending on its thickness. Before work do not forget to switch-off the automatic machines bringing current to the room or the apartment. We choose wire the same material of which the main wiring in the apartment is made. It is undesirable to connect wires of different materials as at big currents the position of joint will be heated, it will lead to wiring ignition. Leading of current to sockets requires rigid strong cable, and the soft cable having multicore wires also will be suitable for the small lamp. It is better to take cable length with stock, superfluous it is possible to bite off then.
2. We begin work. Knife we bare the ends of wire so that the bared part was 1-1.5 cm, but it is no more. We do the same also with that cable which we will join, then we twist them by means of flat-nose pliers. Then we wind the bared places of wire with insulating tape, since the beginning one twist, and then another. For full fire safety we wind from above cap. If it is required to be connected to board, then we connect the ends of cable by means of the screw-driver to the body of board and the output of the time cut-out.
3. Further it is required to carry out cable to the consumer of current. It is better to make it slightly lower than ceiling, beating it brackets to wall, it will not be required to look for nails, they already are complete with brackets. The distance between brackets not less half a meter, and wire is required to be conducted directly, to do turns at right angle. Now, having brought cable to the right place, its other part it is possible to cut off, bare the ends and to connect to the lamp or other device. It is required to Privorachivat wires carefully as it is possible stronger in order to avoid the bad contact. On it our work is finished.