Wall lamps are capable not only to introduce special cosiness in interior, but also allow to allocate indoors functional zones. In retail chain stores it is possible to meet the lamps of various look provided in wide assortment. Mounting of wall lighting instrument is defined by its design.
It is required to you
- - wall lamp;
- - ruler;
- - pencil;
- - knife;
- - screw-driver;
- - drill;
- - drill;
- - dowels;
- - terminal strip.
Instruction
1. Choose the place for wall lamp. Its position on wall has to be comfortable and provide the luminous flux necessary for illumination of functional zone, for example, near kitchen table, chair or berth. If the lamp takes rotary design, the installation site can be chosen with bigger freedom. Two or three same lamps located at the different levels can look especially originally.
2. Examine back surface of the basis of the lamp which will fasten to wall. In the simplest case the lighting instrument can have one or two openings intended for attaching on the screws which are previously screwed in in wall or on special brackets. Also lamps which have special level which is screwed on surface in the beginning meet, and then to it the device body fastens.
3. In the place chosen by you on wall draw horizontal line on which fixture will be located. Note places where it will be required to screw in fastening elements in wall, previously having measured distance between mounting holes in the lamp basis. Drill in opening wall under dowels. Hammer plastic dowels against the stop and screw in them the screws or screws which are included in the package of delivery of the lamp suitable by the size.
4. If the design of the lamp includes mounting bar to which the device fastens subsequently, establish it in the same way, having achieved that the plate has been located horizontally. Attach the body of the lamp to level and against the stop screw up the corresponding side screws. Make sure that all design is assembled reliably attached to wall.
5. When the lamp is not just switched off in the socket by means of electrical plug, and mounted to the stationary wiring laid in wall use special terminal strips at wire routing. In general the technology of mounting of lighting instrument remains to the same.