Fencings serve separations of the site from the street and from adjoining properties. In addition fencings carry out also functional tasks. Any protection has to be reliable, durable, convenient and beautiful.
Instruction
1. At once It should be noted the advantage of wooden fencings. It is that such fencings can be made of cheap local material rather easily. The sanded up pole, poles, brushwood, etc. well will be suitable for this purpose. As framework it is possible to use normal columns. After that it is necessary to make wattled filling of branches of rod, willow, hazel grove or other tree of woods. To build the inclined fence, it is necessary to hammer the lower sharpened ends of switches into the earth at an angle about 60 °.
2. Most often the fence fencing is done of planed levels. For this purpose it is necessary on cord which will be pulled at the level of the top face of the fence, to beat levels. It is recommended to use specially made template at the same time. It represents board which width is equal to gleam between the fence and level beaten to board at right angle. Consider, length of this board has to be equal to fence length. The top faces need to be cut off "on mustache" and to cover with longitudinal board on all length of fence. The fence needs to be covered with emulsion or oil paint. Also sometimes for this purpose use bituminous paints. 5% of aluminum powder or ground mica are their part. For delay of rotting it is necessary to apply additional coat of paint on slanted edges of wooden parts of protection.
3. Gate and gate is the most difficult parts of protection. Consider, they have to be strong, durable and convenient in use. Best of all for their creation to use metal or tree. Gate it is recommended to do double-wing. The general width of this design will be about 3.5 m. It is necessary for entrance to the yard of cars.
4. Special attention should be paid to the base under rod posts. Reliability and durability of work of gate depends on it to a large extent. Rod posts have to be put on depth about 100 cm. Bosoms of hole need to be filled up accurately with crushed stone and to stamp carefully. After that concreting is already made.