Oven heating is heating services, when there is no heat carriers in the form of pipes with water, heating of the house comes due to return of heat from the furnace installed in the center of the house. Furnaces do by brick, various size and purpose. There are they heating, cooking and heating. The main advantages of such heating is environmental friendliness, availability, low cost.
It is required to you
- - red brick;
- - clay;
- - sand;
- - cement;
- - oven accessories (door, podduvalny door, work line rack, grid-iron);
- - trowel;
- - hammer;
- - capacity for mixing of solutions.
Instruction
1. To begin to do oven heating it is necessary at once after construction of walls of the house when there is only internal room, but there are no partitions separating the house into rooms yet. Measure and estimate where you will have rooms of different purpose. Choose design of the furnace of the sizes necessary for you. Drawings of furnaces can be found in bookstores and also on the Internet. The drawing represents poryadovochny laying. The furnace has to stand in the middle of the house so that its walls left to each room and heated air. That is it can warm at the same time four rooms. Calculate so that the fire chamber of the furnace was in kitchen.
2. Soak clay. For this purpose take capacity fill in it buckets 6-7 clays and fill in with water so that from above there was water layer not to exchange of 5 cm. Clay has to be soaked 3-4 days. While clay is soaked, make the base of the furnace. Dig out in the earth under floor hole not less than 40 cm in depth, fill sand down and begin to spread the base of the brick furnace on cement and sand solution. Solution prepare 3 buckets of sand at the rate of 1 bucket of cement. Finish laying of the base on floor height, make cement screed and put on not waterproofing - roofing material will be suitable for this purpose. Let's stiffen to the base within 2-3 days.
3. Take poryadovochny drawings of the furnace and begin to put it. Correctly calculate furnace height so that it did not reach ceiling a little, then carefully insulate pipe from wood structures, having applied that - or, containing asbestos, for example, paronite. After readiness of the furnace heat it small amount of firewood. Find out whether the draft as there is smoke from pipe is good. Plaster the furnace, having closed up all cracks and roughnesses. Do not forget to plaster also and pipe on the attic - it becomes in the fire-prevention purposes. Now you can safely build partitions in your house.