In spite of the fact that door openings rather imperceptible part of interior, its importance is big. It is a little simple to establish aperture, it should be issued still so that he fitted into the general design of the room or even all apartment or the house. Of course, sure bet are platbands. However, even in case of installation of platbands, it is necessary to consider design shortcomings.
Instruction
1. Unfortunately, walls in our houses are constructed so that seldom it is possible to issue all door openings platbands of one width. Of course, all internal apertures of one room after all try to sheathe platbands of one width. However in this case it is important not to forget that I will eat, issued by platbands of different width, looks not beautifully and not esthetically. On the other hand, it will look it better, than total absence of platband from one of the parties.
2. It is important not just to choose identical platbands, but also it is correct to establish them. For example, if it is not possible to level walls in one plane with aperture, it is necessary to choose equal platbands with sample inside out and to put them at an angle to hide difference in the planes. Establish platbands after completion of repair, finishing of walls has to be already complete. Platbands usually at distance of 5 mm from door case under 45-degree corner on the relation to each other fix.
3. Ways of installation also are different. Some prefer from to paste, however in this case further it will not be possible to remove them. It is better for that it is important to whom to have removable platbands to fix platbands or nails, or to insert them into in advance prepared grooves. However you should not beat normal nails platbands as it can spoil exterior not only platband, but also all aperture in general. Professionals do it by special parquet nails with small hat if such were not, from normal thin nails bite off hats. And in order that tacks were not noticeable, platbands can be zashkurit and covered with hard putty and varnish. If platbands have to be sawn, important not to damage their drawing, i.e. it is impossible to saw platband more than on three quarters of its width.
4. One more option of registration of door opening is installation of arch. They can be lancet or round. At the same time arches with round outline are divided into several types: classical (with the correct radius of arch), modernist style (arch with rise), romantic (the arch has direct part in the center with rounded corners) and ellipsoidal (arch in the form of the correct or wrong ellipse). Arches can be monolithic concrete, brick, plaster, plastic and wooden (oak, beechen, pine). At the same time concrete, brick and wooden arches are "universal", that is can be established as outside, and in rooms. Plaster, plastic and arches from chipboard or fibreboard can be established only indoors. Arches can be established in the form of "transom" over rectangular door opening. The most convenient way - use of ready arch apertures, set consists of two arches, four racks, panels for arches and racks, and decorative locks. Besides, the arch can be capital brick. However it is better to construct such arch if width of aperture exceeds 2 meters. At registration of brick arch use compass brick which has one face already another, and the laying is carried out on timbering.