Happens that the door in the apartment is hung so that when opening blocks itself window, and you with displeasure consider dead wall. Naturally, it will be much better if at open door you see window. However, there are also other cases when it is reasonable to move door so that it opened not inside, and outside.
It is required to you
- Screw-drivers, knife, metal ruler, chisel, mall, the hammer with thin brisk, plane, thin french nails, joiner's glue, putty for wood
Instruction
1. For preponderating of door you will need to move latch fixer plate, to make new slots for loops in box and in the door and also to close up old slots. If you intend to change the direction of opening of door, then you will need to transfer door emphasis, and even to rearrange handles. It is possible that the door should be recoloured.
2. Remove door from loops. For this purpose open it and insert from below wedges. Turn out screws from the lower loop. Then do the same with the top loop, having left one screw. You will need the assistant who will hold door until you take the last screw. Accurately take loops from slots. Old slots can be closed up.
3. Now put door on feigned bar and fix it. Plan at face of provision of loops knife on metal ruler. On face side of door plan depth of new slots. Do pro-saws across face up to the required depth.
4. By means of chisel cut the new slot. Apply loop to the place of future fastening and note its situation. Close the rest of the slot tree piece. Grease with glue wooden plate and insert into the slot. Beat plate thin nails. Give to glue time for drying then the site and establish to ostrogayta loops.
5. Turn door latch so that the bevel has fallen on fixer plate. Strengthen door on bar. Door handles and pad on front part should be removed. Take latch from opening and unroll by 180 degrees. Insert latch to opening and attach pad screws. Now it is possible to mount door handles.
6. From door case disconnect plate of fixer and cut out plate from tree by the opening sizes. Paste plate into place and when glue dries, gaps to zashpatlyuyta. Cut off roughnesses by means of chisel and plane.
7. Establish door vertically that the calcaneal bar was located at right angle to door case. Fix door by wedges. Mark places for loops on door case. On lines of marking carry out by knife and choose groove then cut the slot.
8. Hang door, close it and make mark in face side in that place where there will be latch. Apply plate of fixer on tags and circle it with knife on contour. Drill, and then chisel execute openings for uvula. Cut the slot for plate of fixer and attach it in the place by means of screws.
9. Tear off emphasis for door chisel, close door and plan new situation for emphasis on door case. Take emphasis on the new place, establish it on level and beat finally in all places.