There is a mass of options of how to make of a tree a boomerang which returns the hands. That it was really working, it is necessary to give to planning and details a lot of time therefore you should not expect fast results. It is creative, long process which promises much esthetic and moral pleasure, but at the same time demands patience, assiduity, attentiveness and care.
How to make the drawing of a boomerang of a tree?
Production of a boomerang can be considered really engineering work, and it begins with traditional production of the competent and exact drawing. It is the best of all to use ready options – they already consider all features and will not demand calculations, except scaling.
Choice and preparation of wood
It is the best of all to create a boomerang not from the first board, and from strong breeds of wood to which the linden, a birch and an oak belong. Pay attention to the options bent under 90-100 degrees – they will be optimum.
Best of all in search of the necessary snag to go to the forest, having taken the axe or a saw hacksaw and to take at once several dry branches suitable under the requirements described above. If there is a wish to make several boomerangs at once, it is practical to choose a snag with a diameter about 10 cm. If there is no such purpose, it is not obligatory.
If the dry tree was not, it is necessary to stock up with patience and to dry fresh wood – and it will take about a year. It is impossible to pass this step, this option will not give in to processing and will beat off desire to continue work.
To accelerate drying of fresh wood, it is necessary to remove bark and to apply wax on piece faces. So it will evenly dry and will not crack. What strong would not be desire to undertake quicker a boomerang, to dry a tree in the sun or at the battery it is impossible. Optimum the piece will dry out only in a year if to put it in the aired place.
How to make a boomerang of a tree?
When dry knee lies before you, it is possible to start production of a boomerang. The sequence of actions will be following:
- Cut off side parts a plane (preferably) or a circular saw, having made a knee flat and uniform on thickness.
- Clamp a knee a vice and by means of a manual saw hacksaw saw, receiving several preparations 1 - 1.5 cm thick.
- Put a marking according to the prepared drawing. That wings of a boomerang found the necessary profile, apply the drawing on wood and paint over excess parts that it was visible to what line it is necessary to grind off. If with drawings at you of complexity, it is possible to print it it and to paste to preparation.
- With the help the fret saw or the grinder eliminate the excess.
- Further processing follows – by means of the grinder or a nazhdachka it is necessary to process edges of a boomerang. Pay attention: process a boomerang only from the face, and the reverse side has to remain equal, except for edges. It is necessary to operate on this stage slowly and accurately, differently there is a risk to ruin all done work.
- When everything is ready, it is necessary to process a boomerang a small nazhdachka so that to erase traces of work and to give it ideal smoothness.
- That the boomerang did not crack, was not soiled and did not deteriorate, it needs to be processed varnish. At will, it is possible to put with paint a pattern.
Only after the fact that all stages of work will be completed and paint completely will dry out in well aired place, it is possible to start test. Be careful, by means of this subject it is possible to injure involuntarily itself or people around. The optimum place for tests – stadium in deserted hours or other open area with good visibility.