People who use earphones in everyday life should come up sooner or later against an unpleasant situation when they understand that to their accessory there is something wrong. Instead of pure sounding, the sound begins to vanish in earphones, to appear. It happens to one earphone, at once to two. As it is sad, but it is necessary to admit the fact that earphones broke and they need to be repaired somehow.
How to repair earphones if one does not work?
So, if the sound vanishes only from one earphone, then it is necessary to define what the problem consists in. It is necessary to put on earphones, to turn on the music and to check a wire by a bending method on all length. If the problem that the wire in some place broke, then when checking a sound in an ear begins to vanish when you reach the place of breakage of a wire.
Having found out the place of breakage it is possible to start directly repair. For this purpose it is necessary accurately, a sharp knife to cut out the damaged site of a wire, about one and a half centimeters. Then, very carefully, not to damage a wire, to remove a braid from wires. It can be done in two ways:
- To remove isolation by means of a knife. It is necessary to smooth out a wire, approximately, on centimeter.
- It is possible to bare the ends of wires by means of naked flame from the lighter.
All wires have a braid of strictly certain color. At their connection with each other, it is important not to mix.
After the ends of wires are smoothed out them it is necessary to twist with each other. It is possible to twist the ends of wires with an overlap (when tips of two wires are clamped by fingers and twist clockwise until hardly do not twirl). Also wires can be twisted linearly (the smoothed-out ends of wires keep within in parallel each other and also twist). Then junctions of wires are soldered by solder, for the best connection.
Junctions of wires (each wire separately), are isolated by an insulating tape.
How to repair earphones without soldering iron?
If for any reason the soldering iron is absent, and there is no opportunity to solder the increased wires to each other, then there is nothing terrible in it. Just places of twist of wires should be twirled very strongly and when using strongly not to pull and earphones will serve for a long time.
There is also an option when the wire came off earphones in the place where the plug is located and many ask a question as to repair it.
How to repair earphones if the wire tore?
First of all it is necessary to buy in shop of electronics or in computer shop, the same plug. Then follows, very accurately to cut off a wire from the old plug, then to do the same process with the damaged part of a wire, to smooth out conductings, but not one centimeter, but about two. Then it is necessary to untwist or disassemble the old plug and to look what wires, what color are attached to what contact.
Further it is necessary to untwist the new plug, then to attach the smoothed-out wires to its contacts and to strongly clamp them by means of flat-nose pliers so that they did not dangle and sat on the places tight. If there is a soldering iron, then it is desirable propayat junctions for the best contact. Then to assemble the plug to wind, if necessary, the place of an entrance of wires to the plug with an insulating tape. So if earphones them broke it is possible to repair in house conditions, in it there is nothing difficult.
If to follow the provided recommendations of how to repair earphones, then the favourite accessory will serve still for many years and will please with good sounding.
"