Fingerbording – new popular entertainment for youth. One of the most important components of this type of the hobby is the stage. If you didn't get that yet, came it is a high time to create the park in house conditions. On the stage you will be able to do many various high and beautiful tricks.
It is required to you
- - sheet fibreboard,
- - wooden bars,
- - corners for the binding,
- - nails,
- - tools,
- - subject of the cylindrical form,
- - rope,
- - heavy subject (brick).
Instruction
1. Cut the rectangle from the fibreboard of the size necessary to you. Now you will need to bend the received rectangle. In order that to make it, wet the sheet fibreboard warm water, it is necessary that all leaf became wet.
2. Take the cylindrical subject, for example, the 3-liter jar. Press the leaf to bank, turning it. Bend the leaf until at you the corner equal to 90 degrees doesn't turn out. Now the stage already began to get outlines.
3. Fix the form which was got by the stage. For this purpose take the rope and connect the stage.
4. Put the stage the bent ends on the floor. That the stage wasn't curved, put from above the heavy subject, for example, the brick. You can also fix the stage on the clothes dryer. In such situation the stage has to dry about 12 hours.
5. Make support. Take wooden bars and fixing corners. Be defined what height of the stage is necessary to you, measure it. Saw off bars of the necessary sizes, them there have to be 4 pieces. We advise to do height of support on 0.5 see below what you measured. It is necessary to give the certain tension.
6. Create surfaces from which you are going to move down in the stage. Cut pieces of bar 10-11 cm long. Cut the sheet fibreboard, its length has to coincide with stage width, and width of the leaf has to coincide with bar length.
7. Pin the cloth to support if it already dried. If the stage big, call friends to the aid. Beat the stage to support only from the top side.
8. Begin to collect what we prepared in the previous step. Nail the fibreboard to bars. Beat the turned-out shelf to the stage.
9. Measure length and width of the turned-out stage. Cut by the sizes the basis for the stage from the fibreboard. On this basis you can fix it by means of support.