Not all dogs well transfer cold and dampness. Some, especially small, the clothes are necessary for walks in the fall and in the winter. Besides, owners of exhibition long-haired dogs very often worry about keeping wool in an order. Therefore a dog dress — at all not a whim of the owner. It is necessary to know approximately and distance from the tail basis to a joint of a hinder leg.
It is required to you
- Dense, but soft fabric
- Elastic band
- Lightning
- Paper for a pattern
- Centimeter
- Ruler, pencil and square
Instruction
1. Measure your pet. You need to know the back length, a neck grasp, a grasp of a front and hinder leg in the widest part, depth of a breast and distance from a throat to a breast. Length of a back is measured from a neck to the tail basis. Breast depth - distance between forepaws on the edge located between them. The circle of a neck can be measured on a collar.
2. Construct a pattern. Begin to build it from back length. In the area of a back the lightning or a velcro will be sewn. The overalls consist of the main part and a wedge. Define a point on the long party of a leaf And yes postpone from it back length. Designate a point B. From these points draw lines down at an angle 135 °. From a point And lay off the distance equal to a half to trouser-leg length. From this point lower the line parallel to a short part of a leaf, and postpone on it a half of length of a trouser-leg. From a point of B postpone the piece equal to a half of a circle of a neck.
3. From a new point postpone breast depth. Put the end of A1 and from it draw the line parallel to the short party of a leaf down. Postpone the piece equal to trouser-leg length. Carry out a perpendicular and postpone on it trouser-leg width. Make the same on a back trouser-leg. From the turned-out points postpone perpendiculars up and postpone for them trouser-leg length. Draw a line between trouser-legs.
4. You will find a wedge. Its any length, and the greatest width is equal to depth of a breast of a dog. Just in case you will find a wide wedge that then it could be cut.
5. Cut out a pattern and transfer it to fabric. You will find edgings for processing of a mouth and bends. Width of an edging is 5-6 cm. It is better to cut it on slanting. You will find klapata. From length width — 3-5 cm is equal to back length, and. It is possible to make double valves. Do not forget to add 1 cm from each party on seams.
6. Sweep away seams — at first trouser-legs, then tack a wedge to an overalls stomach. Try on and adjust details. If everything is all right, stitch together seams.
7. Hem trouser-legs and insert elastic bands. Process an edging a mouth and also insert an elastic band. Sew an edging to an overalls stomach.
8. Sew a lightning. Sew valves so that they completely closed a lightning. Process seams overloky or a loopy seam if it is necessary.