Laying of the network cable big is not difficult. It is much more difficult to press out an Internet cable, having attached it to the connector. Unfortunately, existence of the blooming tool and a tester which costs much will become the main problem for all who will want to press out independently a cable. But they can be hired in a computer workshop.
It is required to you
- - Twisted pair cable;
- - Connector;
- - Pressing tool.
Instruction
1. Cut off a cable of the necessary length with a small stock. Smooth out it, having cut off a braid approximately on 2 cm. It is possible to make it the same blooming tool in which there are special edges intended for cleaning.
2. Untwine all cable cores, having sorted cores in pairs by to the principle white + color, color. For example, white-orange – orange. Following sequence: blue, orange, green, brown. After sorting of cores, straighten them that their overhang over isolation was identical.
3. To connect a cable to the connector, it is necessary to take it a latch from itself and to insert into wire grooves, observing the above sequence. Cores should test some resistance at an insert in grooves and rest against an edge wall. The cable braid should be clamped in the connector.
4. It was necessary only to insert the connector with a cable into nippers of the blooming device and to press out.
5. Surely check correctness of connection of a cable. It is checked a tester into which insert a cable both ends. If bulbs burn, connection means it is made correctly.