For turning on of the computer the Wake On LAN technology is online used. To implement the present possibility, it is necessary to configure previously the network adapter on receiving special Magic Packet and to install one of free utilities of power management and obtaining data of packages. The awakening option also should be included in the BIOS computer.
It is required to you
- The network interface card and the motherboard with the Wake Up on LAN support
Instruction
1. Previously configure settings of your net board. For this purpose turn into properties of the computer (the right mouse button on "My computer" - "Properties"), select the Equipment tab - "Device manager" (for Windows 7 this point is in the left part of a window).
2. In the appeared tree of the devices connected to the computer select "Net boards" and double-click on the name of your adapter. In a new window go to the Power management tab.
3. Put ticks opposite to the Allow Shutdown of This Device and Allow the Device a Computer Output from a Stanby Mode points. Click "Ok".
4. Load and install one of the utilities allowing to accept Magic Packet. From free programs It should be noted Magic Packet Utility, Wake on LAN. Also on the official site of vendor of AMD it is possible to find similar AMD Magic Packet Utility.
5. Install the selected application and carry out settings according to parameters of your network and the network interface card. As a rule, applications demand to enter the IP address of network and the MAC address of the network adapter. After the end of settings send request after which your computer will turn on.
6. If start did not happen, then check the BIOS settings. For this purpose in turn-on time of the computer clamp the corresponding key which name is usually specified in the lower part of the screen at inclusion. Select the option Power — Power Up Control. In the line Wake On LAN or PCI modem there has to be an Enabled value. Save all changes by means of F10 key and try to restart the computer from the Internet. If the attempt was not successful again, then most likely your network interface card does not support reception of Magic Packet.