If to know technology of mounting of walls and overlappings of the house from vulture of panels, it is possible to build qualitative and inexpensive housing quickly. Such houses are suitable for operation in northern regions, do not demand the powerful basis, allow to save on finishing work.
Houses from vulture of panels warm and pre-fabricated. Speed of mounting of walls and overlappings is caused by constructional feature of basic elements of such building – sandwich of panels (vulture of panels). These products are equipped with special ledges and dredging which simplify process of mounting of walls and overlappings.
Construction stages vulture of the house
Thanks to the small weight the buildings built on the Canadian technology do not need the solid base. For these constructions it is possible to choose the most inexpensive types of the bases: column and tape. Level of deepening of the base will depend on specific conditions of construction site: like the soil, depth of underground waters, climatic features of the region.
Further, on the built basis mount framework which will be fixed by vulture of the panel in required position. For construction of "skeleton" of the house use bar section 10/15 or 15/15 of cm and board of 4/15 cm or 4/20 cm. From bar mount the lower binding to which vertical racks fix. In corners expose dual boards. Mounting of wall is begun with installation of guide of board which fix to binding anchors with a section not less than 12 mm. Then mount at once two panels which have to form corner. Cutting of material on walls has to be such is that there were as little as possible joints. Attaching hoarsed the panel to already established, in face of one of them establish board which fix to binding metal corners. Then sides of panels connect so that both of them covered basic board. After construction of the first level of wall, start mounting of the following. Further, begin to build rafter system. Stack waterproofing on it and mount furring to which cloths of roofing material will fasten. The roof can be warmed, putting in apertures between rafters heater: polyfoam or mineral wool. When the roof is built, start mounting of internal partitions, installation of windows and doors.
In what advantage of the Canadian technology of housing construction?
To build from vulture of panels simply and quickly houses. These buildings perfectly keep heat and provide comfort of operation in severe conditions of the North. Constructions from vulture of panels will cost considerably cheaper, than similar brick. Today there are such sendvich-panels which release with ready external finishing therefore it is not required to spend time and funds for facing of facade. Internal walls do not demand alignment or plastering as vulture of the panel on both sides are sheathed by strong equal cloths of RSD.