Process of laying of tile – process quite labor-consuming. To lay tile at the edges of the room, around doors or window frames not to do, of course, without plitkorez who will help with little effort and to cope waste of time with this task for only a few seconds.
It is required to you
- - Plitkorez,
- - tile,
- - felt-tip pen.
Instruction
1. Before use of plitkorez it is necessary will check integrity of wheel and to make sure of high-quality fixing (it should not move here and there). If the wheel was absolutely erased, try to replace it with new.
2. Drip several drops of oil on wheel and the directing frame.
3. Draw on tile strip felt-tip pen or pencil on which it is necessary to make cut. Put tile so that the wheel corresponded with the line of cutting. You hold strong tile with the left hand, and right undertake the handle of plitkorez.
4. Lower wheel when lowering the handle on cut edge that the wheel has concerned surface. Press a little and move the handle on yourself. It is necessary to make only one pass wheel, otherwise the cut edge will turn out low-quality.
5. To separate tile on the planned strip, it is necessary to expose wings at the level of the lower third of tile. To press slightly the handle and to strike slightly it with palm of the right hand, left it is necessary to hold tile. The tile has to break up on the planned line if it has not occurred, it is necessary to strike a little more feasibly.
6. If the edge has turned out uneven, it is possible to straighten it by means of abrasive paper or grindstone.