Not the instruction in Russian is attached to each razor, sometimes in the instruction just is absent data on how it is possible to disassemble the razor. Razors of Braun not exception. The majority of razors have no throw-over switch of mains voltage. Switch to necessary tension by turn of block of network starter windings, connection of power voltage happens to the help of the corresponding clip depending on mains voltage.
1. Various models of razors of Braun can have differences in the scheme of noise suppressing filters. At one model each starter pillow has 3 conclusions, at another - 4. The razor of Braun has in the connector plastic body the collector electric motor, tension switch which switches windings of coils and also the switch and the switch of sliding knives for hairstyle.
2. The upper part of the body has cutter head with floating knives in which mobile knives rotate. The head from above is closed by cap, the folding head is cutting. During pressing fixer the head is rejected by spring which is built in in loop of cutter head.
3. All mobile knives are set in motion by the wheels supplied with leads and are in coupling with the leading gear wheel which is on engine shaft. The cutting knives are set in motion by the clown of cogwheel.
4. Before disassembling the razor of Braun, it is necessary to disconnect fork from network or to extend batteries. After that to take out block from the razor. Then to open the razor, having removed cutter head for shaving and knives for hairstyle, to take out spring which fixes knives and pulls together body halves. After that it is necessary to unscrew screws in the basis and also the attachment screw. The switch is put in the switched-off position. In the razor measure tension by the alternating current voltmeter in throttle connection points.
5. The switch of the razor is checked ohmmeter, take out block and connect the probe to switch connection point with throttle. To remove the coil, it is necessary to take out from the basis of stub and to unscrew the screws which are under them. Remove the basis, cogwheels, adjusting washers from the electric motor. Then lift springs of holders, having taken them aside for short moustaches. After that it is possible to take out brushes, to unscrew screws and to remove fastening of the stator to the bed together with anchor.
6. On the second diagonal 2 more screws which it is necessary to turn off, remove from the coil the stator, and then and the coil are located.