Safety of the gas equipment in use – one of the main factors. Therefore the majority of modern models of gas-fires and boilers are equipped with systems gas control. They are intended for blocking of supply of liquid fuel, in case of fire blowing-in – in order to avoid gas leak. But sometimes there is need to disconnect gas control.
It is required to you
- - gas pipe wrench
- - tuning screw
- - welder's gloves
Instruction
1. Define the reasons for which the system gas control constantly blocks supply of gas on rings or oven of kitchen stove. Practice shows that one of the most common causes is misuse. The principle of work gas control is based on heating of the temperature sensor. If before certain time to release the gas supply handle, then the control system of leak of gas will disconnect it. In this case it is necessary to maintain 2-5 seconds as it is specified in technical documentation of the producer.
2. If the reason in insufficient gas pressure in the central pipe, setup works in gas-distributing substation are necessary. It is the licensed type of activity in which representatives of gas services are engaged. For check and adjustment it is necessary to submit the application to local office of gorgaz.
3. Before calling the representative of city service of gas, check the crane installed on gas pipe. It can be not completely open, as leads to interruption in supply of fuel on rings. In this case it is simple to remove the cause: it is enough to set the crane to normal position. It is necessary to regulate supply of gas on the equipment the tuning screw.
4. To disconnect gas control the workers having the right only having the corresponding admissions. In this case surely check that the expert performing works has surely made entry in the book on operation of gas devices, having specified date, the nature of the performed works and surname of the expert.
5. It is possible to adjust system gas control independently. For this purpose remove the lower panel of oven of gas-fire and find the sensor gas control. In the form he reminds the round capsule on the end of metal tube. Attentively look at position of the thermocouple: it has to adjoin to tongue of flame hardly. If position of the sensor is displaced, it needs to be adjusted gas pipe wrench or the screw – depending on plate model.