The chair is such usual piece of furniture for any apartment that the few attach them particular importance. There is back, there are sitting and legs that else is necessary. Why to buy convenient chairs which cost heap money in shops? Honestly, it is better to make chair own hands.
It is required to you
- Timber from deciduous breeds of trees;
- Foam rubber;
- Tapestry material or tapestry;
- Screws;
Instruction
1. Let's prepare constituent parts chair. Let's cut two front legs from tree about 45 cm long. Back legs have to have length already 80 cm. Width of legs has to equal about 5 cm. In addition we need to cut couple of side partitions of 40х6 cm. And still four crossbeams of 35х5 cm will be necessary for us for fastening of seat and chair back.
2. We connect parts. We will use for this purpose the nails suitable by the size. At first we will connect two cross crossbeams to back legs. Then we will fasten one of front legs to side partition. Now to the received design we beat two crossbeams by means of which we will fix seat. And, we need to beat front crossbeam so that it was located slightly further joint of crossbeam and leg. What's next? Further we fasten the remained front leg and the second crossbeam among themselves and we beat them to the rest of chair. That the framework of chair has taken the finished form, we fasten front and back parts of chair. It is necessary to varnish framework.
3. Let's be engaged in upholstery. For production of upholstery we use foam rubber. We cut big piece of foam rubber to the necessary sizes (for sitting of 45х45 cm, and for back of 20х45 cm) and we wrap it in tapestry material or tapestry. From below we fix upholstery fabric on foam rubber by buttons or rivets. It is possible to use also the stapler with big brackets. If to thrust several revetings also in upper part of chair, then it is possible to give it even more decorative look.
4. We establish seat with back. For this purpose we will need screws. The screw driver has fixed the upholstered piece of foam rubber from back and lower parts of chair on crossbeams. On each crossbeam about 6 screws have to leave approximately. That's it.