How to make falls on the seasonal dacha

How to make falls on the seasonal dacha

It is possible to create falls on the seasonal dacha also most if there are patience and desire to acquire some knowledge in this question. Even on the small site it is possible to place pond with falls. The main thing is to observe proportions and the general concept of garden.

The system of falls, usually, consists of two parts: the pond from which water undertakes and there returns, and falls. If at the dacha there is already reservoir, then work on arrangement of falls is a little facilitated. In this case it will be necessary to build the height from stones and to connect the pump for water circulation. If there is no reservoir on the site yet, it is necessary to stock up with patience and to start all laborious work from scratch.

The first that needs to be made before works, it to decide on the place for reservoir, its form and the sizes. It has to fit harmoniously into design of garden and not to be too big for it. It is necessary to consider that any element of the garden site has to be continuation previous. Reservoir depth can be different too. If the pond is necessary only as the tank for water circulation, then rather small depth. But, if in pond it is going to place plants or small fishes, then such reservoir has to be not less than 1 m in depth.

After the bowl of reservoir is prepared for use, begin the falls device. That it looked more beautifully and gracefully, do several cascades, and for this purpose it is necessary to create different obstacles, that is ledges which height has to be no more than 30 cm for water. Begin to do such ledges from the lower tier. Stones put on cement slurry. From below falls it is recommended to make low sides that falling water did not scatter splashes far beyond construction. It is in advance necessary to think over at what height and what streams water will fall. Proceeding from these wishes establish hose in the right place.

In order that water rose by falls top, the pump, hose and the low-voltage transformer is required. It is established indoors. The pump is installed on pond bottom, hoses and the cable going to current network mask that they were not visible. In the pump attach 2 hoses to each of two openings, and that which will go from the pushing-out opening stretch on the top of falls, and lower another on reservoir bottom. Thus, it will be necessary only to connect current, and the system of falls will earn.

It is possible to decorate falls with garden figures or lamps and also plants which land near construction.

Author: «MirrorInfo» Dream Team


Print