For production of stone in house conditions special forms are necessary. Forms of any sizes and casting drawings are provided on sale in wide assortment. They are made of quality and reliable polyurethane and polypropylene. The stone made in these forms turns out qualitative, the drawing is as close as possible to natural stone and is provided for every taste the most exacting buyer. If you do not want to be spent for purchase of ready forms, then it is possible to make them independently.
It is required to you
- - planed tes
- - sheet of metal
- - power saw
Instruction
1. Independently it is impossible to make polypropylene or polyurethane forms as their production happens on special processes and they are poured out on the special equipment. In house conditions it is possible to make wooden or metal molds. As these materials are not flexible, the stone cannot be taken from them if not to make their folding.
2. For production of folding wooden molds it is necessary to take planed tes. to measure width and length according to the necessary size. In sides to make pro-saws for installation of two parties longwise. The bottom at form can be not done in general, and to establish it on plain surface, for example on thick glass or metal.
3. For production of metal forms it is possible to take iron or stainless steel. To cut two plates on width and length. The bottom can also be not established. On longitudinal sides to make the pro-saws which are not reaching the end and to collect form.
4. It is necessary to fill in mix for production of stone in the forms oiled lubricating. After drying of product to take out from forms by method of full dismantling of forms.
5. The forms made independently cannot give the same beautiful edge of face side of stone as cast polypropylene or polyurethane. The stone will just turn out with plain surface. Therefore if you want to make beautiful stone, then it is better to buy forms. Especially as they cost absolutely not much.