The convenient round table can be made most of those materials which at you near at hand. Perhaps, you already have old table which wants to be remade, or there were plywood or furniture board after repair. Depending on the table-top size the table can be both big lunch, and small journal.
It is required to you
- - Pine furniture board;
- - Bar;
- - Tape measure;
- - Screws;
- - Metal corners;
- - Glue PVA;
- - Cord;
- - Pencil;
- - Electrofret saw;
- - Chisel;
- - Abrasive paper (fine-grained and coarse-grained)
- - Furniture varnish;
- - Brushes or roller.
Instruction
1. Make round table-top of furniture board. Put board on horizontal surface. Decide on the radius of your round table. Tie cord one end to big nail, and other end to pencil. String length between pencil and nail has to equal to table radius.
2. Thrust nail in the middle of furniture board. Hardly pull cord and circle radius with pencil. Use this adaptation as compasses.
3. Cut on marking the electrofret saw round table-top. Process rough edges of board coarse-grained abrasive paper, remove it wooden hangnails. Then walk at the edges fine-grained abrasive paper that edges were smooth, without catches.
4. Make crosswise underframe. It will enhance rigidity of table-top. Measure necessary parts on bar. Saw off them the fret saw. At once process nazhdachka from all directions.
5. Screw bar crosswisely screws under table-top. Try to screw in screws from underframe, then the top of table will turn out absolutely equal, it can be covered with transparent lacquer. Only count length of screws not to pierce table-top through.
6. Think what your table will lean on. If you are going to make one thick leg, you need to calculate stability of design. Cut from bar not only the main leg of table, but also foot which make, as well as underframe, crosswise. At once screw or paste on thorns underframe to leg and check stability.
7. Hollow chisel in bar, in the middle of underframe, deepening by the leg size. It is possible to strengthen dowelled connection, and it is possible to grease deepening with PVA glue. Implant leg into deepening. Stiffen connection by two or four metal corners, having fixed them between bar and leg.
8. Varnish all your new table. Grind small abrasive paper and again cover with three-four varnish coats. If you need to give to table certain color, use mordant. And it is possible to take the tinted varnish at once.